Serving Spruce Grove, Stony Plain & the Greater Edmonton Area 📞 780-932-7337 | ✉ info@homeprosgroup.com
Serving Beaumont Since 2002

Attic Insulation in Beaumont.

Blown-in attic insulation in a town that mostly doesn’t need it yet — and we will happily be the company that tells you so. Free attic check, measured depth, one written number if there is work to do.

4.9 average from 46 Google reviews — read them on Google.

Beaumont · Blown-In Top-Up · Free Attic Check
Free attic check
We measure what you have, then quote one flat number.
  • Depth measured & photographed before any quote
  • Blown fiberglass or cellulose — your call
  • Baffles kept clear at the eaves
  • No Beaumont travel surcharge
Request My Free Quote
A Young Town

Most Beaumont Attics Are Fine. Here Is Which Ones Aren’t.

Beaumont did most of its growing in the last twenty-five years, which makes it the one market in our area where the honest answer is usually “you don’t need this.” We would rather say that clearly than pretend otherwise.

The modern town: built to a number that still holds

The subdivisions that took Beaumont from village to city were closed up under recent code, and their attics measure accordingly. If your home is from the 2000s onward, the probability that you need a top-up is low, and the free inspection will most likely end with us telling you to keep your money and spend it on something else.

The older core: the genuine candidates

Around the original village centre and the streets nearest it, there is housing that predates the growth spurt by decades. Those attics follow the usual pattern — a standard that was reasonable at the time, thinned by forty or fifty years of settling, and thinner still at the perimeter. That is where the work in this town actually is, and it is a small enough number of homes that we can be honest about it without hurting ourselves.

What newer Beaumont homes do get: moisture

A tight, modern, well-insulated house pushes warm humid air upward, and if any of it reaches a cold attic it freezes on the underside of the roof sheathing all winter and melts out in one go come spring. Homeowners find it as a stain on a bedroom ceiling in April and reasonably assume the roof is leaking. It usually isn’t. Attic rain is the most common attic complaint we get from new Beaumont builds, and adding insulation is precisely the wrong response to it.

The trip is free either way

We are already in town regularly for furnace and duct cleaning, so an attic inspection is not a special expedition. Measured depth, photographs, a straight answer.

The honest Beaumont summary

Built after about 2000: you almost certainly need nothing, and we will tell you that for free. Older core, or seeing spring ceiling stains: worth having us up there, though the second one is a moisture problem rather than an insulation one.

Marked depth ruler standing in blown attic insulation showing measured inches
Measured, photographed, and handed to you either way.
Frost formed on the underside of attic roof sheathing in an Alberta home
The newer-build complaint here: moisture, not missing depth.
What’s Included

What A Blown-In Top-Up Actually Involves

Insulation is one of the easiest trades to fake, because nobody climbs up to check. Here is what we do, and what you get to see afterwards.

A measured depth, not an estimate

We take depth readings at several points across the attic — not one convenient spot by the hatch — because settling is never even. You get the readings and the photos before you get a price, whether or not you hire us.

Fiberglass or cellulose — you choose

Blown fiberglass doesn’t settle much and stays put in a windy attic. Blown cellulose fills tighter around framing and top plates and is recycled. Both hit the same R-value; we’ll tell you which suits your attic and then blow whichever you pick.

Baffles, and the gap at the eaves

An attic needs air moving from the soffits upward. Insulation blown into that gap chokes the ventilation and causes exactly the moisture problem it was supposed to prevent. We keep the eave channel open, with baffles where they’re missing.

Depth markers and a photo record

Marked rulers get left standing in the insulation and the finished depth is photographed. Anyone — you, a home inspector, a buyer’s agent five years from now — can put their head through the hatch and read what was installed.

Our Process

How An Attic Top-Up Goes

01

We inspect and measure — free, and before any price

Depth readings across the attic, a look at the eave gap, the hatch, the bath-fan ducting and the state of what’s already there. You get the photos and the numbers regardless of whether you book the work.

02

You get one written number

Square footage, the depth you have, the depth you’re going to, the material, and a single all-in price. Not a per-bag rate that moves once the truck is in your driveway.

03

We prep before anything gets blown

Baffles at the eaves, a dam around the attic hatch so the new material doesn’t spill out every time you open it, and depth markers set across the span.

04

We blow to depth, then photograph it

The hose runs through the hatch and the material goes in to the marked depth. Then the finished attic is photographed against the markers, and those photos are yours.

What we check before we blow — and tell you about

Bath and range fans that vent into the attic instead of through the roof, gaps around the hatch and ceiling penetrations, and any sign of moisture. Burying those problems under fourteen inches of new insulation makes them worse and hides them. If your attic has one, you’ll hear about it before we start rather than after — and if it’s outside what we do, we’ll say so and you can call the right trade.

Beaumont Pricing

No Hidden Fees. No Upsells. Ever.

Insulation is the one thing we don’t publish a flat rate for — and it’s worth explaining why, because everything else on this site has a number attached to it.

The attic inspection is free

Measured depth at multiple points, photographs, and a straight answer about whether you actually need the work. No charge, no obligation, and you keep the numbers even if you hire somebody else.

One written number, all in

Material, labour, baffles, hatch dam and cleanup in a single figure before we start. If the attic turns out different from the quote, we stop and talk to you — the price doesn’t quietly grow.

R-50 or R-60 — priced both ways

We quote the two depths side by side so you can see what the extra costs. Once you’ve paid for the crew and the trailer, the incremental depth is mostly material — it’s the cheapest R-value you’ll ever buy.

Never priced by the bag

Per-bag pricing is how an insulation quote doubles. Bags are our problem. Depth across your ceiling is what you’re buying, and that’s what the number covers.

Why we won’t quote an attic over the phone

Because the honest answer depends on three things nobody knows over the phone: your attic’s square footage, how much insulation is up there now, and how evenly it’s spread. Anyone who gives you a firm insulation price without going up there is either guessing or planning to revise it later. We’d rather drive to your Beaumont address for free and tell you the truth — including, quite often, that your attic is fine and you should keep your money.

Cold upstairs? Ice on the eaves?

Free attic inspection anywhere in Beaumont — measured depth, photos, and a written number.

Signs You’re Short

Does Your Beaumont Attic Actually Need Topping Up?

You can see the ceiling joistsIf the tops of the joists are visible above the insulation, you’re at roughly R-20 or less — about a third of what a new home here is built to.
Icicles and ice dams every thawHeat escaping through the ceiling melts the snow on the roof, which refreezes at the cold eave. The ice is a symptom; the attic is the cause.
The upstairs can’t hold temperatureBedrooms that run cold in a January snap and hot in July are usually losing through the ceiling, not the windows everyone blames.
Frost or drips in the attic come springWarm damp air leaking up from the house freezes on the underside of the sheathing all winter, then melts all at once. It gets mistaken for a roof leak most years.
Nobody has touched it since the house was builtAn attic blown to the standard of 1985 or 1998 has also spent decades settling. What was installed and what’s measurable today are two different numbers.
The roof is being replaced anywayThe crew is already there and the attic is already disturbed. It’s the cheapest time to deal with the insulation you were going to deal with eventually.
While We’re There

Most Customers Book More Than One

Bundling saves a second trip and a second booking — add-on rates only apply while the truck is already in your driveway.

Beaumont FAQ

Attic Insulation Beaumont: Frequently Asked Questions

Very probably not. Homes built here in the last couple of decades went in under recent code and generally measure where they should. We will still come and check for free, but you should expect the answer to be no — and if anyone tells you otherwise without measuring, ask them for the readings.
Usually it isn’t. In a tight modern home it is far more often attic rain: warm damp household air reaching the cold attic, freezing on the sheathing all winter, and melting out over a few warm days. Blowing more insulation on top of that traps the moisture and makes it worse, so it matters that whoever comes out can tell the two apart.
The ones around the original village core and the older streets nearest it — housing that predates the growth spurt. Those attics were insulated to an older standard and have had decades to settle. It is a genuinely small share of the town, and we are not going to pretend it is larger than it is.
Edmonton and the surrounding region sit in climate zone 7A. A new home here needs an effective R‑59 attic, or about R‑49.2 if it has an HRV — the code trades approved ventilation against envelope performance. Those are effective numbers, which is why a compliant attic is usually blown deeper than the label suggests. The full breakdown, including what R‑50 and R‑60 look like in inches, is in our guide to what Alberta code requires in an attic.
Either is defensible. The first R‑20 does most of the work, so the jump from R‑50 to R‑60 saves comparatively little on its own — but because you’ve already paid for the crew and the equipment, that last stretch is nearly all material and it’s the cheapest R-value in the job. If budget is the constraint, R‑50 isn’t a compromise; it’s the threshold the rebate programmes themselves picked.
Usually, yes — and that’s the normal job. Old fiberglass or cellulose that’s dry and undisturbed is fine to build on; it hasn’t stopped working, there just isn’t enough of it. The exceptions are insulation that’s wet, mouldy, matted flat, or contaminated by rodents, which needs to come out first. That’s insulation removal, and we’ll tell you at the free inspection which of the two you’re looking at.
Neither, honestly. Blown fiberglass resists settling and doesn’t mind a draughty attic; blown cellulose packs in tighter around framing and top plates and is made from recycled paper. Both reach the same R-value at the depths we install. We’ll recommend one for your specific attic and then install whichever you decide on — we don’t earn more either way.
No. We do attics, and only attics. Drill-and-fill wall insulation is a genuinely different job with different risks in an older Alberta home, and we’d rather be good at one thing than adequate at two. If walls are your problem we’ll say so and you can bring in someone who specialises in it.
We stop, we don’t disturb it, and we tell you what you’re looking at. Vermiculite in a pre-1990 attic may contain asbestos, and removing it is regulated abatement work in Alberta requiring a licensed contractor — that is not us and we won’t pretend otherwise. You’ll get photographs and a plain explanation, and there’s no charge for the visit.
Most homes are a single visit of a few hours, start to finish, and you can stay in the house while we work. The hose runs from the trailer through the attic hatch, so the crew’s traffic through your home is limited to that one route, which gets protected before anything starts.
Beaumont Coverage

Serving All Of Beaumont

From the original village core to the newest phase, measured for free.

Centre-Ville · Coloniale Estates · Dansereau Meadows · Eaglemont Heights · Elan · Forêt · Goudreau · Le Rêve · Montrose Estates · Place Chaleureuse · Ruisseau · Triomphe Estates

Everything we do here lives on the Beaumont service page, and the full region is on service areas.

Attic Insulation Nearby

Not In Beaumont?

Get In Touch

Request Your Free Beaumont Quote

Tell us a little about your home and we’ll get right back to you with honest, flat-rate pricing — no obligation.

Call Us
780-932-7337
Hours
Mon–Sat 8:00 AM – 5:00 PM
Service Area
Beaumont · Greater Edmonton Area

Free Quote Request

No obligation. We’ll reply with flat-rate pricing.

Or call us directly at 780-932-7337

Call Now Free Quote