Serving Leduc Since 2002

Attic Insulation in Leduc.

Blown-in attic insulation across Leduc, on some of the most wind-exposed ground in the region. Free attic check, measured depth, and one written number before anything starts.

4.9 average from 46 Google reviews — read them on Google.

Get a Free Quote 📞 Call 780-932-7337

Leduc · Blown-In Top-Up · Free Attic Check

Free attic check

We measure what you have, then quote one flat number.

Depth measured & photographed before any quote
Blown fiberglass or cellulose — your call
Baffles kept clear at the eaves
No Leduc travel surcharge

Request My Free Quote

An attic is measured, not guessed at

Depth is the only number that matters, and it takes ten minutes with a ruler to establish. See exactly how we measure, what we blow and where the code numbers come from on the main attic insulation page.

How It Works →

Open Ground

Leduc Attics Lose Their Edges Before They Lose Their Middles

Leduc sits on flat, open land beside an international airport, with very little between the town and the wind. That single fact shapes what we find in its attics more than any other.

Wind-washing: the local signature

Air driven in under the soffits does not stop politely at the edge of the insulation. It pushes through the first few feet of loose-fill, scours it back toward the middle of the attic, and steadily strips depth from the perimeter — the exact strip of ceiling that sits over your outside walls and does the most work. In Leduc we routinely open a hatch to a respectable-looking attic and then find nearly bare joists two feet in from the eaves. Baffles and a properly rebuilt perimeter are often the most valuable part of the job here, ahead of raw depth.

The older core: Telford, Linsford Park, Leduc Estates, West Haven Park

These are the town’s settled neighbourhoods, insulated to the standards of their decades and thinned by both time and that wind. They are also where the biggest heating-bill improvements are available. Homes here frequently measure under half the current requirement once the perimeter is taken into account rather than ignored.

Southfork, Windrose, Suntree, Tribute and the newer south

Leduc’s modern growth was built to current code and generally does not need topping up. It is, however, exposed to exactly the same wind, and a new attic can still lose its edges if the baffles were skipped or crushed during construction. That is a small, cheap fix and worth finding.

Why the free look matters more here

Because the failure is at the perimeter, a homeowner poking their head through the hatch sees a perfectly good attic and concludes everything is fine. It is the one local condition that genuinely cannot be self-diagnosed from the hatch, and it takes us ten minutes to settle. The furnace and duct visit covers the other half of the same heat-loss conversation.

Don’t judge a Leduc attic from the hatch

The view from the opening is the deepest part of the attic. The part that matters is two feet in from the eaves, and on exposed streets here it is often a fraction of what you can see.

Ventilation baffle installed at an attic eave keeping the soffit air channel clear — Baffles hold the vent channel open and stop wind stripping the edge.

Marked depth ruler standing in blown attic insulation showing measured inches — Read at the perimeter as well as the centre — that is where Leduc attics fail.

What’s Included

What A Blown-In Top-Up Actually Involves

Insulation is one of the easiest trades to fake, because nobody climbs up to check. Here is what we do, and what you get to see afterwards.

A measured depth, not an estimate

We take depth readings at several points across the attic — not one convenient spot by the hatch — because settling is never even. You get the readings and the photos before you get a price, whether or not you hire us.

Fiberglass or cellulose — you choose

Blown fiberglass doesn’t settle much and stays put in a windy attic. Blown cellulose fills tighter around framing and top plates and is recycled. Both hit the same R-value; we’ll tell you which suits your attic and then blow whichever you pick.

Baffles, and the gap at the eaves

An attic needs air moving from the soffits upward. Insulation blown into that gap chokes the ventilation and causes exactly the moisture problem it was supposed to prevent. We keep the eave channel open, with baffles where they’re missing.

Depth markers and a photo record

Marked rulers get left standing in the insulation and the finished depth is photographed. Anyone — you, a home inspector, a buyer’s agent five years from now — can put their head through the hatch and read what was installed.

Our Process

How An Attic Top-Up Goes

We inspect and measure — free, and before any price

Depth readings across the attic, a look at the eave gap, the hatch, the bath-fan ducting and the state of what’s already there. You get the photos and the numbers regardless of whether you book the work.

You get one written number

Square footage, the depth you have, the depth you’re going to, the material, and a single all-in price. Not a per-bag rate that moves once the truck is in your driveway.

We prep before anything gets blown

Baffles at the eaves, a dam around the attic hatch so the new material doesn’t spill out every time you open it, and depth markers set across the span.

We blow to depth, then photograph it

The hose runs through the hatch and the material goes in to the marked depth. Then the finished attic is photographed against the markers, and those photos are yours.

What we check before we blow — and tell you about

Bath and range fans that vent into the attic instead of through the roof, gaps around the hatch and ceiling penetrations, and any sign of moisture. Burying those problems under fourteen inches of new insulation makes them worse and hides them. If your attic has one, you’ll hear about it before we start rather than after — and if it’s outside what we do, we’ll say so and you can call the right trade.

Leduc Pricing

No Hidden Fees. No Upsells. Ever.

Insulation is the one thing we don’t publish a flat rate for — and it’s worth explaining why, because everything else on this site has a number attached to it.

The attic inspection is free

Measured depth at multiple points, photographs, and a straight answer about whether you actually need the work. No charge, no obligation, and you keep the numbers even if you hire somebody else.

One written number, all in

Material, labour, baffles, hatch dam and cleanup in a single figure before we start. If the attic turns out different from the quote, we stop and talk to you — the price doesn’t quietly grow.

R-50 or R-60 — priced both ways

We quote the two depths side by side so you can see what the extra costs. Once you’ve paid for the crew and the trailer, the incremental depth is mostly material — it’s the cheapest R-value you’ll ever buy.

Never priced by the bag

Per-bag pricing is how an insulation quote doubles. Bags are our problem. Depth across your ceiling is what you’re buying, and that’s what the number covers.

Why we won’t quote an attic over the phone

Because the honest answer depends on three things nobody knows over the phone: your attic’s square footage, how much insulation is up there now, and how evenly it’s spread. Anyone who gives you a firm insulation price without going up there is either guessing or planning to revise it later. We’d rather drive to your Leduc address for free and tell you the truth — including, quite often, that your attic is fine and you should keep your money.

Cold upstairs? Ice on the eaves?

Free attic inspection anywhere in Leduc — measured depth, photos, and a written number.

Get a Free Quote 📞 780-932-7337

Signs You’re Short

Does Your Leduc Attic Actually Need Topping Up?

You can see the ceiling joistsIf the tops of the joists are visible above the insulation, you’re at roughly R-20 or less — about a third of what a new home here is built to.

Icicles and ice dams every thawHeat escaping through the ceiling melts the snow on the roof, which refreezes at the cold eave. The ice is a symptom; the attic is the cause.

The upstairs can’t hold temperatureBedrooms that run cold in a January snap and hot in July are usually losing through the ceiling, not the windows everyone blames.

Frost or drips in the attic come springWarm damp air leaking up from the house freezes on the underside of the sheathing all winter, then melts all at once. It gets mistaken for a roof leak most years.

Nobody has touched it since the house was builtAn attic blown to the standard of 1985 or 1998 has also spent decades settling. What was installed and what’s measurable today are two different numbers.

The roof is being replaced anywayThe crew is already there and the attic is already disturbed. It’s the cheapest time to deal with the insulation you were going to deal with eventually.

While We’re There

Most Customers Book More Than One

Bundling saves a second trip and a second booking — add-on rates only apply while the truck is already in your driveway.

Insulation RemovalQuoted with the same visit Furnace Cleaning$345 + GST, ducts included Duct CleaningThe same flat rate Dryer Vent Cleaning$60 with this visit

Leduc FAQ

Attic Insulation Leduc: Frequently Asked Questions

Because the hatch shows you the best part of it. On Leduc’s open, windy ground the failure happens at the perimeter — air driving in under the soffits strips loose-fill back from the eaves, leaving the ceiling thinnest directly over your outside walls. It is invisible from the opening and it takes ten minutes to check properly.

They are simple channels at the eaves that keep the soffit-to-attic airflow open while stopping that same air from blowing your insulation around. An attic needs the ventilation, so the answer is not to block it — it is to direct it. In this town they do more good than almost anywhere else in the region.

Usually no work, but the check is free and here it is genuinely worth taking. New homes on exposed Leduc ground can still lose their edges if the baffles were crushed or missed during the build, and that is a cheap fix that protects insulation you already paid for.

Edmonton and the surrounding region sit in climate zone 7A. A new home here needs an effective R‑59 attic, or about R‑49.2 if it has an HRV — the code trades approved ventilation against envelope performance. Those are effective numbers, which is why a compliant attic is usually blown deeper than the label suggests. The full breakdown, including what R‑50 and R‑60 look like in inches, is in our guide to what Alberta code requires in an attic.

Either is defensible. The first R‑20 does most of the work, so the jump from R‑50 to R‑60 saves comparatively little on its own — but because you’ve already paid for the crew and the equipment, that last stretch is nearly all material and it’s the cheapest R-value in the job. If budget is the constraint, R‑50 isn’t a compromise; it’s the threshold the rebate programmes themselves picked.

Usually, yes — and that’s the normal job. Old fiberglass or cellulose that’s dry and undisturbed is fine to build on; it hasn’t stopped working, there just isn’t enough of it. The exceptions are insulation that’s wet, mouldy, matted flat, or contaminated by rodents, which needs to come out first. That’s insulation removal, and we’ll tell you at the free inspection which of the two you’re looking at.

Neither, honestly. Blown fiberglass resists settling and doesn’t mind a draughty attic; blown cellulose packs in tighter around framing and top plates and is made from recycled paper. Both reach the same R-value at the depths we install. We’ll recommend one for your specific attic and then install whichever you decide on — we don’t earn more either way.

No. We do attics, and only attics. Drill-and-fill wall insulation is a genuinely different job with different risks in an older Alberta home, and we’d rather be good at one thing than adequate at two. If walls are your problem we’ll say so and you can bring in someone who specialises in it.

We stop, we don’t disturb it, and we tell you what you’re looking at. Vermiculite in a pre-1990 attic may contain asbestos, and removing it is regulated abatement work in Alberta requiring a licensed contractor — that is not us and we won’t pretend otherwise. You’ll get photographs and a plain explanation, and there’s no charge for the visit.

Most homes are a single visit of a few hours, start to finish, and you can stay in the house while we work. The hose runs from the trailer through the attic hatch, so the crew’s traffic through your home is limited to that one route, which gets protected before anything starts.

Leduc Coverage

Serving All Of Leduc

From the older core to the newest southern phase, measured for free.

Black Stone · Bridgeport · Caledonia Park · Corinthia Park · Deer Valley · Lakeside Estates · Leduc Estates · Linsford Park · Meadowview Park · North Telford · Robinson · South Park · South Telford · Southfork · Suntree · Tribute · West Haven Park · Windrose · Woodbend

Everything we do here lives on the Leduc service page, and the full region is on service areas.

Attic Insulation Nearby

Not In Leduc?

BeaumontAttic Insulation DevonAttic Insulation EdmontonAttic Insulation Sherwood ParkAttic Insulation

Get In Touch

Request Your Free Leduc Quote

Tell us a little about your home and we’ll get right back to you with honest, flat-rate pricing — no obligation.

Call Us

780-932-7337

Email Us

info@homeprosgroup.com

Hours

Mon–Sat 8:00 AM – 5:00 PM

Service Area

Leduc · Greater Edmonton Area

Free Quote Request

No obligation. We’ll reply with flat-rate pricing.

Or call us directly at 780-932-7337

Call Now Free Quote